How to Check the Spark on Porsche 944
If you're the proud owner of a Porsche 944, then you know that it's a car that requires special care and attention. One of the most important aspects of maintaining your Porsche is making sure that the spark is working properly. In this article, we will show you how to check the spark on your 944 so that you can be sure that it's running smoothly.
The Common Spark Problem
The most common spark issue on the Porsche 944 is a faulty ignition coil. This can occur if the coil has been damaged or if it's filled with excessive carbon deposits. If this is the case, then you will likely notice that your car won't start or run properly and may make unusual noises from the engine. Sadly, many have experienced the Porsche 944 ignition coil problem before.
As well as a damaged spark plug, the issue can be caused by a worn or damaged distributor cap and rotor arm. This means that the current isn't able to pass correctly into the spark plugs, leading to misfiring and other issues. Elsewhere, your vehicle may have experienced a failure in the ignition control module, an ASD relay failure, or a faulty crankshaft position.
How to Check the Spark on a Porsche 944
To check your Porsche 944's spark, you'll need a few tools: a feeler gauge and a spark plug socket, as well as a spark plug gap tool. Start by disconnecting the spark-plug wires from your distributor cap and unscrewing the spark plugs.
Once removed, check for signs of excessive wear or corrosion on the spark plugs; if you find any problems, it's probably time to replace them. Next, use your feeler gauge to measure the spark plug gap. If the gap is greater than the manufacturer's recommended spec then you'll need to adjust it with a spark plug gap tool.
After adjusting the gap, re-install your spark plugs and reconnect the wires to your distributor cap. Now, you can start up your Porsche 944 and check for any signs of poor spark. To do this, turn on the ignition and look at the spark-plug coils; if you see sparks coming from the wires, you know that your spark plugs are in good condition.
Finally, it's important to check the condition of your distributor cap and rotor. If there is any evidence of excessive wear or corrosion then they should be replaced. Additionally, make sure that the rotor has no burnt or broken parts. If everything looks good, you can reassemble your engine and enjoy the benefits of a smoother-running Porsche 944.
Naturally, you can take your vehicle to a Peoria Porsche Expert if you're worried about doing any of this yourself.
How to Check Spark Plugs on a No-Start Porsche 944
What if your Porsche 944 won't start? Before you panic, here's what to do. First, check the spark plugs for wear and damage. The process is the same as described in the previous section. After removing each one, inspect it carefully and replace any that are damaged or worn out. Also, make sure that they're clean and properly gapped.
If the plugs are fine, then check the spark plug wires for damage and make sure they are firmly connected to each plug. If there's any corrosion or dirt on them, clean them off with a wire brush.
Finally, check that all the connections between your engine components and the spark plugs are secure. If they're not, tighten them up or replace the connections if necessary. Again, auto repair specialists are ready to help if you need it!
Read More: How Much Does it Cost to Replace a Mercedes-Benz Power Steering Pump?
